Providing Driveline Solutions For Over 30 Years

 
High Angle CV Joints

The BAMF 42 Degree

This isn't just your average, everyday CV. With lift kits getting and horse power increasing, more and more recreational vehicle drivers are searching for a drive shaft solution that will transmit the greater amounts of torque needed with extreme angles.

Most other CV components will flex to around 30 degrees at most, but the BAMF CV Joint will go up to 42-degrees outperforming any other. The BAMF 42 Degree CV Joint can be used on your front or rear drive shaft eliminating any vibration and withstand punishment other CV’s cannot.

Here are a few reasons why it's called the BAMF:

  • 42 degree angle capability
  • Balances @ over 2500 RPMs
  • 1.5 ton capacity (comparable to Dana 1410 series)
  • .750" diameter stud to align and center the CV unit (others use .500")
  • All moving parts are serviceable through easily accessible grease fittings
  • Can be machined for tube sizes from 2.00" to 3.00"
  • Smooth operation
  • Developed using continuous duty industrial components
  • Easy to install

 

Custom Driveshafts

Pat's Driveline can design, engineer and manufacture new original drive shafts for any application size, speed and power requirement. Contact your nearest Pat’s Driveline technician specialist today!